Kanalog 1.0 Hardware

Parameter Specification
Analog
DAC Outputs (8) +/- 10V  @ 10ma, recommended load >2Kohm
12 bit - update rate 11.1KHz all 8 channels
ADC Inputs (8) +/- 10V 100Kohm input Impedance
12 bit - update rate 11.1KHz all 8 channels
Optos
Opto Isolated Outputs (8) Max differential voltage 80V  25ma
Opto Isolated Inputs (8) 3-24V input, internal 10KOhm series resistor
Differential
Differential Input Receivers (16) ANSI TIA/EIA-422-B, ANSI TIA/EIA-423-B
+/-7V common mode range, 200mv sensitivity
Internal 470ohm termination
Relay Drivers
N channel FET Switches (8) 24V @ 1 Amp max
Open Drain switches to ground
Digital I/O
GPIO - LVTTL (8) Outputs Source/Sink 12ma
(8) Inputs LVTTL, 3.3V 1a max
±15V
On-board DC-DC Generator 2 Watts (70ma each supply)
RS232
Driver/Receiver EIA/TIA-232-F
Terminal Strips
Screw Terminals 112 Pluggable Screw Terminals
(7) x 16 pin
5mm pitch
Watchdog
Charge Pump DSP communication enables
(1) Relay Driver, FET Switch 24V @ 1A
Logic Supply
Voltage +5V ±10%
Typical Current 0.5 A
Environment
Operating Temperature 0-40 C
Storage Temperature 0-40º C
Humidity 20-90% Relative Humidity, non-condensing
Dimensions
Length 8.5 inches (216 mm)
Width 7.0 inches (178 mm)
Height 0.75 inches (19 mm)
Green
RoHS Compliant